Puresilk™’s Chlorine Control System has two parts. The upright electrolytic cell houses two specially-coated, electrically charged plates. When slightly salty water passes between the plates, chlorine is released. And once through the cell the salt reforms, ready to start the whole process over again.
Managing and monitoring the chlorination process is a sophisticated microprocessor.
It makes the Puresilk™ Chlorine Control System the safest, easiest, most natural and most economical way to chlorinate a pool or spa through the use of some very ingenious and innovative technology. For example...
Automatic Self-Cleaning Cells
The Microprocessor automatically reverses the polarity of each electrolytic plate cleaning them completely.
Automatic Output Limiting
This protects the power supply from over-salting and allows salt to be added without switching the chlorinator off. (No fuses, no circuit breakers needed.)
Automatic Low Salt Warning
If salt levels fall below the optimum threshold, the diagnostic display scrolls a message requesting a salt top up.
Automatic Low Salt Stop & Re-Start
If salt levels fall below the minimum point the cell shuts down and a message scrolls. The cell then continues to re-test and when normal salt levels are restored the cell automatically re-starts.
Automatic Memory Save
If there’s a power failure all information is stored for at least seven days. There are no batteries that can go flat or leak.
24-Hour Boost Mode
The system can be set to operate at full output for 24 hours then automatically return to normal operation.
Automatic Pump Protection Monitor
If the pump is starved of water, the CCS switches the pump off to stop it running dry. Timing can be adjusted for different hydraulic conditions and pump types.
Automatic Pump Flushing
Cell power switches off 30 seconds prior to pump switch off, to flush the cell and pump of concentrated chlorine. This prevents high chlorine levels corroding pipe work, heat exchangers or in-floor cleaning systems.